This diagram illustrates some of the most common circuits found in a typical 200 amp circuit breaker box. The breakers are installed in a service panel so that contact is made with one of two hot bus bars that run down the middle of the box. The hot wire for a circuit is connected to the breaker by a set screw on the base.
If you’re installing a new doorbell, a remote controlled device makes for the simplest installation and doesn’t require any of the circuitry illustrated on this page. All that’s required is to mount the button near an exterior door and the chimes in a convenient, central location inside the house. No need to run wires or splice into household circuits, fresh batteries are all that’s required.
This page contains several diagrams for wiring a switch to control one or more receptacle outlets including a split receptacle and multiple outlets wired together.
A doorbell circuit for two or more doors will have a separate contact on the chimes for each button included. At the chimes, one wire from each button is spliced to the output wire on the transformer. The second wire is connected to one of the contact screws on the chimes.