A doorbell circuit for two or more doors will have a separate contact on the chimes for each button included. At the chimes, one wire from each button is spliced to the output wire on the transformer. The second wire is connected to one of the contact screws on the chimes.
This diagram illustrates wiring for a circuit breaker with a built-in ground fault circuit interrupter. This 20 amp ground fault interrupter breaker is a form of gfci that can be installed at the circuit source. This kind of circuit is used for dishwashers, whirlpool spas and other locations where water contact is likely.
This diagram illustrates some of the most common circuits found in a typical 200 amp circuit breaker box. The breakers are installed in a service panel so that contact is made with one of two hot bus bars that run down the middle of the box. The hot wire for a circuit is connected to the breaker by a set screw on the base.
This diagram illustrates the wiring for a bedside lamp with two sockets. The top socket A, holds a standard incandescent bulb. The second socket B, typically holds a small, low-wattage bulb similar to a night light bulb. The switch allows for energizing the top bulb only, the night light only, both bulbs at once or for turning both bulbs off.
This type of switch will be referred to as a 2 circuit lamp switch when shopping at home stores. Don’t mistake this for a three way switch (pictured below), the two do not function in the same way.
This diagram is similar to the one above, but the switch comes before the new light in the circuit. New cable is run from the receptacle to the new switch location and from there to the light location. The switch may also be added in the the same box with the receptacle as in the diagrams at this link, where the two are installed in a double-gang electrical box.
The plain wire is the hot. If the cord isn’t marked with a bead then the strands of wire will be different colors. In these cases the silver wire is the neutral and the brass colored wire is the hot. The plug on the lamp cord holds another clue to polarity with the wide prong being the neutral and the narrow one the hot. Older lamp cord will have prongs that are the same size. This is because polarity was not observed on electric lamps until the development of grounded circuits.
This drawing shows the wiring for adding a new light fixture using an always-hot receptacle outlet as the source. New cable is run from the receptacle to the new fixture location and a switch loop cable is run from there to the new switch location.