If you’re installing a new doorbell, a remote controlled device makes for the simplest installation and doesn’t require any of the circuitry illustrated on this page. All that’s required is to mount the button near an exterior door and the chimes in a convenient, central location inside the house. No need to run wires or splice into household circuits, fresh batteries are all that’s required.
Here a 2-way push-button switch is wired to a lamp with 2 bulbs. This diagram can be used to rewire an old push-button lamp with a new switch replacement. The hot wire from the cord is connected directly to the black wire on the switch and the neutral is spliced to the neutral contact on each bulb sockets. The red and blue wires from the switch are each connected to the hot contact on one of the bulb sockets.
With this lamp, bulb A can be turned off and on independently and switch B can turn on bulb 1 alone, bulbs 2 and 3 together with bulb 1 off, bulbs 1, 2 and 3 all on at the same time or all three off.
This diagram shows the wiring for a switch to control multiple receptacles. The source for the circuit is at the switch and the receptacles are wired using pigtail splices to make the connections.