The wiring in this diagram is for adding a new light fixture to a switched receptacle, i.e. one that is hot only when a switch is on. These are commonly used to turn a table or floor lamp on and off from a wall switch.
To add a new outlet to a group of receptacles already in place, splice the new wires to one set of wires on one of the existing receptacles. In this diagram each receptacle is wired to the next using the terminals to pass the voltage along. To provide voltage to a new receptacle, remove the wires from one set of terminals on the existing outlet and splice in the new wires and a pigtail back to each terminal.
This circuit diagram shows the wiring for a new receptacle outlet connected at a light fixture. The source at the fixture is always hot and a switch loop controls the light. New 2-wire cable runs from the fixture box to the new receptacle and the source hot, neutral, and ground are splice to it along with a pigtail back to the fixture circuit. With this arrangement the new receptacle is always hot.
This diagram is similar to the one above, but the switch comes before the new light in the circuit. New cable is run from the receptacle to the new switch location and from there to the light location. The switch may also be added in the the same box with the receptacle as in the diagrams at this link, where the two are installed in a double-gang electrical box.
The battery is the weakest link here and should be the first place to look for trouble. The battery can be replaced with a large flashlight-type dry cell rated at 12 to 16 volts and if the wires are still intact and the contacts clean, the doorbell should come back to life.
Here a receptacle is added to a 3 way light circuit before the first switch. It is not controlled with the switches but is instead always hot. The source hot, neutral and ground are spliced to a 2-wire cable that runs to the new outlet. The 3 way switches and light are then wired in the usual way with the common on SW2 spliced to the source hot and the light hot wired to the common on SW1.
This diagram shows the wiring for a switch to control multiple receptacles. The source for the circuit is at the switch and the receptacles are wired using pigtail splices to make the connections.
If you’re installing a new doorbell, a remote controlled device makes for the simplest installation and doesn’t require any of the circuitry illustrated on this page. All that’s required is to mount the button near an exterior door and the chimes in a convenient, central location inside the house. No need to run wires or splice into household circuits, fresh batteries are all that’s required.